I sent my son to his mom’s with one of the USB Serial boards I built along with a breadboard, an RBBA a pile of resistors and an led array. I thought about this arrangement and decided that I would try to build a breadboard attached programmer that would not be dangling off the edge of the board and in the way.
I am wondering if this isn’t the way to go with the seminar kits.
Board Positive (link to rev A board at 600%)
I am considering a rev B. The tx and rx are reversed and I think I should put 3 pin headers on the power rails. I am also thinking about putting the 3.3v on the inner rail and the 5V on the outer rail on the positive side.
I also made a couple of these but I am missing something and this one doesn’t work (yet)
